Can Present Sensor with Quick Connect electrical The can present sensor is

The can present sensor is used on all EVO and WG8/10 systems

Tread: Flat Tread

This four pin connecting cable is 5m (16

the mounts raise the equipment off the floor for easier cleaning and inspection

Lane 2 part length - Approximately 3

Can Present Sensor with Quick Connect electrical The can present sensor isThe can present sensor is used on all EVO and WG8 10 systems and comes with an assembled 3 wire quick connect Commonly referred to as "First and Last can sensors", this inductive proximity sensor is used to detect the presence of a can at the first fill head and last CO2 purge tube. An additional can present sensor is found near the seamer's entrance. A can must be present at these sensors for the filling seaming cycles to start.