SKU: 39113665124
Ships within 48 hours · Estimated delivery Sep 6 - Sep 11
*Printer med bemærkelsesværdige fine detaljer
Spectrum - Nylon PA6 - CF15 - 1
CAS Number 67-63-0
abrasion-resistant
* Installs much easier than masking tape and film typically used and with less chance of air bubbles
TPM - Wash Solvent - 5L 3DE ASA+ - 1.75mm *Printer med bemærkelsesværdige fine detaljerWash Solvent TPM Wash Solvent (Tripropylene glycol monomethyl ether) is a non flammable, low odor solvent that can be used to clean and dissolve uncured resin on SLA DLP 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before it needs to be replaced. * Compatible with Formlabs Finish Kit, Form Wash and Form Cure * 5 litres ! ATTENTION ! TPM is not currently certified for use with Formlabs
US$ 449.50
US$ 199.50
US$ 249.50
US$ 124.50
US$ 349.50
US$ 199.50
US$ 199.50
US$ 139.65
US$ 124.50
