Geared DC Motor with Magnetic Encoder Outputs - 7 VDC 1:20 Ratio Shipping:2-4 Weeks Because its address is changeable

Because its address is changeable

or 8 wire stepper motors

you can just solder wires directly to the holes

We added some extra goodies to make this GPS FeatherWing better than a breakout: a FET-driven ENABLE pin so you can turn off the module using any microcontroller pin for low power use

We\'ve broken out the I2C pins to our Qwiic system so no soldering is required to connect it to the rest of your system but if you would prefer

Geared DC Motor with Magnetic Encoder Outputs - 7 VDC 1:20 Ratio Shipping:2-4 Weeks Because its address is changeableThe first step in a robotics project is to get a motor spinning. Once you've done that, you quickly learn that not all motors go the same speed, even if they are the same part number! There are always variations that relate to voltage, environment, and manufacturing changes. So, the second step is to figure out how fast it's going! Turns out that's not so easy, but the best way to get started is to add an encoder wheel and an optical or magnetic