Mounting Bracket for Glideforce Industrial-Duty Linear Actuators - Aluminum Shipping:1 day Thanks to the module's low

Thanks to the module's low noise amplifier

It also holds up to the DMX standard which requires electrical isolation between the controller and communication side to avoid ground loops

which greatly reduces the power consumption

This slider has a plastic interior with circulating ball bearings to make it slide smoothly along the railing

please check the WiKi for the detail

Mounting Bracket for Glideforce Industrial-Duty Linear Actuators - Aluminum Shipping:1 day Thanks to the module's lowThis bracket was designed specifically for the Glideforce Industrial Duty (ID) linear actuators . It is machined out of a single piece of aluminum and has been tested to 1700 kgf [3800 lbs or 17,000 N] of static load, which is well above the highest static loads the ID actuators are rated for. The mounting pin has a 0. 498 (12. 6 mm) diameter. This bracket is sold individually, and two brackets are required for each linear actuator. See the bracket